Terminal Panel Features - NEC NP-PA550W User Manual

Terminal Panel Features

14
1. COMPUTER 1 IN/ Component Input Connector (Mini D-Sub 15 Pin) (→ page 13, 143, 148)
2. COMPUTER 1 AUDIO IN Mini Jack (Stereo Mini) (→ page 143, 148)
3. COMPUTER 2 IN / Component Input Connector (Mini D-Sub 15 Pin) (→ page 143, 148)
4. COMPUTER 2 AUDIO IN Mini Jack (Stereo Mini) (→ page 145)
5. COMPUTER 3 IN/Component (R/Cr, G/Y, B/Cb, H, V) Connectors (BNC × 5) (→ page 143, 148)
6. COMPUTER 3 AUDIO IN Mini Jack (Stereo Mini) (→ page 143, 148)
7. HDMI IN Connector (Type A) (→ page 144, 145, 149)
8. DisplayPort IN Connector (→ page 144)
9. MONITOR OUT (COMP. 1) Connector (Mini D-Sub 15 Pin) (→ page 146)
10. AUDIO OUT Mini Jack (Stereo Mini) (→ page 146)
11. S-VIDEO IN Connector (Mini DIN 4 Pin) (→ page 147)
12. VIDEO IN Connector (RCA) (→ page 147)
13. VIDEO/S-VIDEO AUDIO IN L/MONO, R (RCA) (→ page 147)
14. LAN Port (RJ-45) (→ page 150)
15. USB Port (Type A) (→ page 60)
16. PC CONTROL Port (D-Sub 9 Pin) (→ page 219)
Use this port to connect a PC or control system. This enables you to control the projector using serial communica-
tion protocol. If you are writing your own program, typical PC control codes are on page 219.
17. REMOTE Connector (Stereo Mini)
Use this connector for wired remote control of the projector using the NEC optional remote control.
Connect the projector and optional remote control using a commercially available wired remote control cable.
NOTE: When a remote control cable is connected to the REMOTE connector, infrared remote control operations cannot be
performed.
7 8
11 12 13
15 1 2
9 10 5
7
1. Introduction
3 4
16
17
6