Table of Contents
Advertisement
SETTING UP YOUR TV
m
B
b
Use
or
to move through the list to select a
channel, and then press OK to view.
In ATV mode, some areas may receive duplicate
stations. There may not be a clear picture or the signal
may be weak, so the station order can be changed
using ATV Manual Tuning.
REMEMBER: Press TV at any time to select between
ATV and DTV (DTV TV/DTV RADIO/DTV TEXT if
available) modes.
NOTE: The time will be set automatically by
transmission but can be advanced or decreased by
using Local Time Setting in the DTV Settings screen.
PLEASE NOTE
The Quick Setup menu can also be accessed at any
time from the SETUP menu.
Ant/Cable In (if available)
From this menu, you can set the RF input configuration to cable.
a
Press MENU, and select SETUP menu.
b
b
Use
to highlight Ant/Cable In and use
select Antenna or Cable.
NOTE: When you attempt to change the Ant/Cable
In setting, a warning message will appear followed by
PIN entry (if PIN has been set) and a prompt for Auto
Tuning.
c
When Ant/Cable In is set to Cable, the following
setting options will be provided in the Auto Tuning
screen.
B
b
Press
or
to select an item, and then press
to select your desired option.
Auto Tuning
Tuning Mode
Start Scan
DTV
Scan Type
Start Frequency
End Frequency
Modulation
Symbol Rate
Network ID
C
c
or
to
C
c
or
DTV and ATV
Quick Scan
Auto
Auto
Auto
Auto
Auto
16
With the exception of DTV Scan Type and DTV Modulation
items, all of the following items will have 2 operating modes.
The first is Auto where the values for each item are preset by
the system. The second is an Input mode where you will be
able to enter a single value in place of the pre-set value. If no
channel is currently tuned and the Input state is chosen, a
system default value will be shown. However, if a channel is
currently tuned when the item is accessed, the value of the
current channel will be displayed.
DTV Scan Type:
This item determines whether a Quick Scan or a Full Scan will
be executed.
The Quick Scan is a simplified version of the Full Scan that is
designed to complete in less time.
DTV Start Frequency:
This sets the frequency from which the scan will begin.
DTV End Frequency:
This sets the frequency at which the scan will end.
* Valid entry range for frequency items is 113.000-
858.00 for C-Book/Other and 114.000-858.00 for
Nordig-C. If numbers outside of this range are
entered, the values will automatically be set to the
min. or max. valid value as appropriate.
DTV Modulation:
You can choose from five QAM modulation settings.
DTV Symbol Rate:
This is the baud rate (KS/s) of the scan.
* Valid entry range for Symbol Rate is 4000-7200. If a
number outside of this range is entered, the value will
be automatically set to the min. or max. valid value as
appropriate.
DTV Network ID:
This is the Network ID to be utilized for the scan. This item is
greyed out when DTV Scan Type is set to "Full Scan".
* Valid entry range for Network ID is 1-65535. If a
number outside of this range is entered, the value will
be automatically set to the min. or max. valid value as
appropriate.
Advertisement
Table of Contents
