Hdmi Rgb Range; H./V. Position; Vga - Toshiba 32CV711B Owner's Manual

Press ▲ or ▼ to highlight Base Colour
Adjustment and then press ► or
Advanced Video
Cinema Mode
NR
CTI
Adaptive Luma Control
Active Backlight
Blue Screen
3D Colour Management
Base Colour Adjustment
Enter
OK
Press ▲ or ▼ to select an option, then
press to enter the adjustment setting
window.
Base Colour Adjustment
Hue
Red 0
Green 0
Blue 0
Yellow 0
Magenta 0
Cyan 0
Reset
Enter
OK
4
Press ◄ or ► to select Hue, Saturation,
or Brightness, then press ▲ or ▼ to
adjust the settings as required.
NOTE: To return to the original factory settings,
select Reset and press

HDMI RGB Range

Adjusts RGB full range signal automatically.
When Limit is selected the RGB signal's output
range is 16 to 235. When Full is selected the
RGB signal's output range is 0 to 255.
In the PICTURE menu, press ▲ or ▼ to
highlight Advanced Video and press ► or
to enter.
Press ▲ or ▼ to highlight HDMI RGB
Range and press ◄ or ► to select Auto,
Full, or Limit.
NOTE: If the HDMI connection is capable of
1080p and/or the television is capable of refresh
rates greater than 50Hz or supports Deep Colour,
a Category 2 cable will be required. Conventional
HDMI/DVI cables may not work properly with this
mode.
.
On
Auto
7
On
Off
On
Select Back Exit
RETURN EXIT
Saturation Brightness
0 0
0 0
0 0
0 0
0 0
0 0
Select Back Exit
RETURN EXIT
.

H./V. Position

Adjust the horizontal and vertical position of the
picture.
In the PICTURE menu, press ▲ or ▼ to
highlight Advanced Video and press ► or
to enter.
Press ▼ to highlight H./V. Position and
press ► or
H.Position
V.Position
Adjust
OK
Press ▲ or ▼ to select H. Position or V.
Position and press◄ or ► to adjust.
NOTE: For PC input, V. Position adjustment is
not linear. In another words, when you adjust
V. Position, the OSD value will change by 2 or
greater value depending TV's calibration process.
The VGA adjustment is available only when the
input source is PC and your TV is receiving a
computer signal.
In the PICTURE menu, press ▼ to
highlight VGA and press ► or
Select Auto Adjust for automatic adjusting,
or press ◄ or ► to manually adjust the
H.Position, V.Position, Phase, or Clock.
Auto Adjust
H.Position
V.Position
Phase
Clock
Enter
OK
33
CONTROLS AND FEATURES
to enter.
H./V. Position
0
0
Select Back Exit
RETURN EXIT

VGA

to enter.
VGA
5
-1
11
127
Select Back Exit
RETURN EXIT