Switching On; Using The Remote Control; Using The Side-Panel Controls; Using The Touch Sensor - Toshiba 19SL738B Owner's Manual

42SL738B:
COMMON
INTERFACE
CI Card
R
(3)
VIDEO INPUT L
Video
USB
USB
Headphone
HDMI 3

Switching on

Before switching on the television, make sure to
connect the aerial cable, and select TV as the
input source.
If the RED LED is off, check that the mains plug
is connected to the power supply. If the picture
does not appear, press
may take a few seconds to appear.
To put the television into Standby mode, press
on the remote control. To view the picture, press
again. The picture may take a few seconds to
appear.

Using the remote control

To set up the television, you need to use the on-
screen menus. Press
see the menus.
The on-screen menu appears as a list of five
topics. As each symbol is selected by pressing ◄
or ►on the navigation ring on the remote control,
its respective options will appear below.
To use the options, press  or  on the
navigation ring to move up or down through them
and use , ◄ or ► to select the required choice.
Follow the on-screen instructions. The functions
of each menu are described in detail throughout
the manual.
DVB
R
AUDIO
L
VIDEO
HDMI 3
GREEN LED -
On Timer/EPG Timer On
on the remote control, it
on the remote control to
TOUCH SENSOR

Using the side-panel controls

To alter the volume, press –
To alter the programme position, press 
Press MENU and
sound and picture options. Press MENU to finish.
To select the external input, press
through the list until the appropriate input source
is selected as described on page 38.
Please always refer to the owner's manual of the
equipment to be connected for full details.

Using the touch sensor

To use Touch Sensor on the television, use your
finger to touch the indication on Touch Sensor.
To alter the volume, touch on –
To alter the programme position, touch on 
.
Touch MENU and –
the sound and picture options. Touch MENU to
finish.
To select the external input, touch
move through the list until the appropriate input
source is selected as described on page 38.
19
SETTING UP
IR SENSOR
RED LED - Standby
BLUE LED - Power on
+.
, , , or to control the
to move
+.
+ or   to control
.
to