If the RED Stand By LED is unlit, check that the plug is connected to the power supply. If the picture
does not appear press
on the remote control, it may take a few moments.
To put the television into Standby press
on the remote control. To view the television press
again. The picture may take a few seconds to appear.
For energy saving:
We recommend that you use the television with the factory settings. The factory settings are for
Unplugging the mains plug will cut energy use to zero for all televisions. This is recommended when
the television is not being used for a long time, e.g. when on holiday.
5HGXFLQJ WKH EULJKWQHVV RI WKH VFUHHQ ZLOO UHGXFH HQHUJ\ XVH (QHUJ\ HI¿FLHQF\ FXWV HQHUJ\ FRQ-
sumption and thus saves money by reducing electricity bills.
NOTE: Putting the television into standby mode will reduce energy consumption, but will still draw
Using the Remote Control
To set up the television you will now need to use the on screen menus. Press MENU on the remote
control to see the menus.
7KH RQVFUHHQ PHQX DSSHDUV DV D OLVW RI ¿YH WRSLFV $V HDFK V\PERO LV VHOHFWHG E\ SUHVVLQJ
on the navigation ring on the remote control.
To use the options, press
WR HQWHU WKH VXE PHQX 7KHQ SUHVV
RQ WKH QDYLJDWLRQ ULQJ WR
move up and down through the menu and use
to select the required choice. Follow the on-
screen instructions. The functions of each menu are described in detail throughout this manual.
Using the Side-Key Controls
to adjust volume.
to change programme selection, then press
to adjust programme selection.
Press and hold
until Source List is displayed, then press
to scroll through the list until
desired input source is located.
NOTE: Inserting the headphone plug will mute the sound from all speakers.