Ant/Cable/Satellite (If Available) - Toshiba 42VL863B Owner's Manual

SETTING UP YOUR TV
k
C c
Press or to view the DTV (digital channel) or ATV
(analogue channel) lists.
l
b B
Use or to move through the list to select a
channel, and then press OK to view.
In ATV mode, some areas may receive duplicate
stations. There may not be a clear picture or the signal
may be weak, so the station order can be changed
using ATV Manual Tuning.
REMEMBER: Press TV at any time to select between
ATV and DTV (DTV Ant TV/Radio/Text, DTV Cable TV/
Radio/Text, DTV Sat TV/Radio/Text if available)
modes.
NOTE: The time will be set automatically by
transmission but can be advanced or decreased by
using Local Time Setting in the DTV Settings screen.
m
Select Next and press OK. The Satellite Settings
screen will appear. From this window, you can add the
satellites that you wish to tune and configure detailed
settings for each one individually. See "Satellite
Settings" on page 17.
Satellite Settings
Switch Type
LNB Power
No. Satellite
ASTRA 19.2˚E
1
2
3
4
Transponder : 1/83 (10743 MHz)
Dish Type : Fixed
Lower LOF (MHz) : 9600
Upper LOF (MHz) : 10600
Highlight Done and press OK.
n
If your satellite dish is movable, the following
Positioning screen will appear.
Positioning
Satellite : ASTRA 19.2°E
Transponder
Go to 0
Go to Stored Position
Step Size
Positioning
Signal Level
B b
Press or to highlight Positioning, and then press
C c
or to find the dish position with the strongest
signal level.
None
On
Dish LNB
1 1
Done
1/83 (10743 MHz H)
1
W E
Store Position
B
Press or
OK to store the dish position. Repeat steps 13 and 14
for the next satellite as necessary.
If your satellite dish is not movable, the Positioning
screen will not appear.
Adjust the dish position manually for the maximum
Signal Level strength.
Highlight Done and press OK.
o
If the reception testing completes successfully, the
Auto Tuning startup screen will display.
Auto Tuning - Satellite
Satellite
Scan Option
You can select Scan Option from Free to Air and All.
p
B
Press or
OK.
The television will start to search for available DVB-S
channels. The progress bar will indicate the scan
status.
When the search is complete, the Auto Tuning results
screen will display the total number of services found.
q
B
Use or
channel, and then press OK to view.
PLEASE NOTE
The Quick Setup menu can also be accessed at any
time from the Setup/System Setup menu.

Ant/Cable/Satellite (if available)

From this menu, you can set the RF input configuration.
a
Press MENU /
b
B
Press /
c
Press OK to display System Setup menu.
d
B
Press or
C c
or to select Antenna, Cable or Satellite.
NOTE: When you attempt to change the Ant/Cable/
Satellite setting, a warning message will appear
30%
followed by PIN entry (if PIN has been set) and a
prompt for Auto Tuning.
16
b
to highlight Store Position and press
Start Scan
ASTRA(19.2°E)
Free to Air
b
to highlight Start Scan, and then press
b
to move through the list to select a
C c
to highlight Setup icon.
C c
to highlight System Setup icon.
b
to select Ant/Cable/Satellite and press