Download Print this page

Whirlpool AKT 477/IX Instructions For Use page 4

77cm gas on glass induction and gas hob, black glass akt 477/ix

Advertisement

TROUBLESHOOTING GUIDE (INDUCTION ZONE)
• Before contacting After-sales Service:
• read and follow the instructions given in the section "Operating instructions".
• Connect the hob to the electricity supply and check that the supply has not been shut off.
• Clean the hob and dry it thoroughly.
• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.
ERROR CODE
DESCRIPTION
The hob switches off and after
Continuous pressure on
30 seconds emits an acoustic
control panel area
signal every 4 seconds
The control panel switches off
C81, C82
because of excessively high
temperatures
The connection voltage is
F42 or F43
wrong
F12, F21, F25, F36, F37, F40,
F47, F56, F58, F60
If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately from
the power supply.
After-sales Service
Before contacting After-sales Service:
• Try to solve the problem (see "Troubleshooting guide (induction zone)").
• Switch the appliance off, wait 30 seconds then switch it on again. to see if the fault persists.
If after the above checks the fault persists, contact the nearest After-sales Service.
Always provide:
• a brief description of the fault;
• the exact type and model;
• the service number (number after the word Service on the rating plate. "See figure in the next page") is located on the underside of the
cooktop or on the warranty booklet;
• your complete address and phone number.
If any repairs are required, please contact an authorized After-sales Service as indicated in the warranty.
Failure to comply with these instructions may compromise the safety and quality of the
product.
RATING PLATE
MODEL
POSSIBLE CAUSES
Water or utensils on control panel
Clean the control panel
The internal temperature of
Wait for the hob to cool down
electronic parts is too high
before using it again
The sensor detects a discrepancy
Disconnect the hob from the
between the appliance voltage and
mains and check the electrical
that of the mains supply
Call the After-Sales Service and specify the error code
SERVICE NUMBER
USER ADVICE
Energy saving tips
For optimum results, observe the following advice:
• Use pots and pans whose bottom diameter is equal to that of the cooking zone.
• Only use flat-bottomed pots and pans.
REMEDY
• If possible, keep pot lids on when cooking.
• Cook vegetables, potatoes, etc. with little water in order to cut down cooking time.
• Use a pressure cooker to to save even more energy and time.
• Make sure you place the pot or pan in the centre of the cooking zone outlined on the hob.
Safeguarding the environment.
Packaging
The packaging material is 100% recyclable and marked with the recycling symbol
Electrical Appliances.
connection
This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health.
• The symbol
on the appliance, or on documentation enclosed with the appliance, indicates that this product must not be treated as
household waste, but must be delivered to the nearest collection centre for the recycling of electrical and electronic appliances. Disposal
must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment,
recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste.
Declaration of Conformity
• This hob is suitable for contact with foodstuffs and complies with EEC (CE) regulation n. 1935/2004.
• The appliances are designed solely for use as cooking appliances. Any other use (e.g. for room heating) is considered as improper use
and potentially dangerous.
• The appliances are designed, built and sold in compliance with:
• safety objectives of the "Low Voltage" Directive 2006/95/EC (which replaces 73/23/CEE and subsequent amendments);
• Protection requirements of EMC Directive 2004/108/EC "Electromagnetic compatibility";
• the requirements of Directive 93/68/EEC;
• safety requirements of EEC Directive "Gas" 30/396/EEC.
5019 619 01340

Advertisement

loading

This manual is also suitable for:

Akt 477/ix akt 477/ixAkm 359Akt 477477/ix