Whirlpool AKR 809 MR Important Safety Instructions Manual page 8

DESCRIPTION AND USE OF THE HOOD
1. Control panel
2. Grease filter
3. Grease filter release handle
4. Halogen lamps
5. Sensor
Digital control panel with sensors
1. Motor OFF/Stand-by key
2. Speed decrease key
3. Speed increase key
4. ON/OFF light key
5. Grease filter alarm reset
6. "6th Sense" key /"Air Quality Control" (Automatic Operation)
7. Carbon filter alarm reset
Speed 1 notification LD1
Speed 2 notification LD2
Speed 3 notification LD3
Speed 4 notification LD4
"Air Quality Control" operation mode notification LD5
1. OFF/Stand-by key
To put the hood in Stand-by press 1 for at least 2 seconds. This operation enables all keys, puts the hood in Stand-by mode (hood ready for operation. Keys "1"
and "6" come on) and activates the "6th Sense" mode.
Press key "1" again for at least 2 seconds to switch the hood OFF and disable all keys with the exception of key "4".
2. Speed decrease key
3. Speed increase key
The speed of the motor may be increased or decreased, from speed one up to intensive speed, and vice versa, by pressing keys "2" and "3" respectively.
Press and hold down keys "2" or "3" to keep increasing/decreasing the speed at one second intervals.
The current speed is shown by the bar, which will gradually extend, at set intervals, depending on the set speed, in accordance with the following:
• Speed 1
LEDs "LD1" on.
• Speed 2
LEDs "LD1" and "LD2" on.
• Speed 3
LEDs "LD1", "LD2" and "LD3" on.
• Speed 4 (intensive speed)
LEDs "LD1", "LD2" and "LD3" on, LEDs "LD4" flashing.
Note: speed 4 is the intensive speed and is timed.
As a standard, the hood will operate at this speed for 5 minutes, after which time speed 2 will resume.
To deactivate this function before the 5 minutes expire press "2".
4. ON/OFF light key
Press the key to gradually switch the lights on/off varying their intensity.
GB18