Table of Contents
Advertisement
5. Initialization
While the control unit is unplugged connect
the two supplied 9-volt batteries which are al-
ready located inside the control unit. Close
the
cover
of
the
control
unit
and
tighten the four screws. Plug in the control
unit to a suitable power supply. The control
unit will perform a basic systems check.
During initialization the system checks the
batteries, pump, optical probe and pump
connections to confirm that they are
properly connected and in working order.
Important:
Never place hands or objects near the
cutting blades of the Pumpfix
®
F.
If the entire system has been installed
correctly the green ʻPOWERʼ LED will turn on
and remain on. The Pumpfix
®
F is now ready
for operation.
When the system is ready for operation,
make sure that the red manual closure lever
for the backwater flap is in the ʻFLAP OPEN
(FREE HANGING)ʼ (vertical) position. If it is
not, open it with the red manual closure lever.
11
Advertisement
Table of Contents
