Table of Contents
Advertisement
1
1-1
Introduction
1-2
Necessary Documents
TDH-6 Series Hot Oil Large Temperature Control Units
General Information
Your AEC TDH-6 Series hot oil temperature control unit circulates
thermal transfer-type oil through your process and to precisely,
automatically, and reliably maintain it at a temperature you can
select. The operating range of your temperature control unit is
from 100°F to 550°F (38°C to 288°C). The unit is best suited for
use with SterlTherm™ Heat Transfer Fluid. A recommended list of
commercially available heat transfer fluids can be obtained through
Sterling Customer Service.
Rapid recirculation of the fluid provides a close and uniform
temperature relationship between the
PROCESS
lines. This does, of course, depend on the configuration
of your process, and any restrictions within the mold.
This recirculation, combined with the immersion heater and
optional cooling capability, gives fast and accurate response to
bring the fluid up to temperature, or to changes in the settings
when needed.
Performance is assured through matching the unique AEC
controllers to the AEC high temperature system. The two systems
are fully integrated to achieve accurate control.
The following documents are necessary for the safe installation,
operation, and maintenance of your AEC TDH-6 Series hot oil
large temperature control unit. You can obtain additional copies
from AEC, Inc. Make sure that appropriate personnel are familiar
with these documents:
This manual.
The electrical schematic and connection diagram in the control
enclosure.
The manuals for accessories and options you've selected.
The customer parts list in the control enclosure.
TO PROCESS
and
FROM
Page 7
Advertisement
Table of Contents
