Changing the translucence ratio of the
characters (Blend Level)
You can set the translucence ratio (color density)
of the characters in the Spectrum analyzer/
Panorama/Wall paper/Screen saver/Slide show
mode.
By setting this level down, you can adjust the
characters in the display to appear opaque.
1
Playback or receive the source (radio,
CD, MS, MD, or AUX).
2
Press (GRAPHIC).
3
Press < or , repeatedly to select
“Char Setup.”
Each time you press < or ,, the item
changes as follows:
Wall Paper y Panorama y Jacket
Pic y ClipMotion y Slide Show y
Picture Del y Char Setup
4
Press (ENTER).
5
Press M or m to select “Blend Level.”
6
Press (ENTER).
7
Press < or , to select the
permeation ratio (Level 0-15).
The lower the level, the paler the display
characters.
8
Press (ENTER).
9
Press (GRAPHIC).
The display returns to the normal display.
Notes
• In Standard/Clock mode, you cannot change the
translucence ratio of the display characters.
• Set “Auto Clear” to “ON” (page 38), the translucence
ratio of the display characters does not change.