Siemens M75 User Manual page 47

46 Setup
• Auto mode
Your phone is "visible" to other BT
devices for several minutes. You will
then be asked if "visibility" should
continue.
Shown in the display
Bluetooth switched on.
¨
Bluetooth visible to others.
©
Data services
Default setting and activation of the
connection profiles for
plications. The phone default setting
varies from service provider to serv-
ice provider. Consult your service
provider or go to this address on the
Internet for more information
www.siemens.com/
mobilephonescustomercare
in the "FAQ" section.
HTTP profile
The phone default setting varies
from service provider to service pro-
vider. Consult you service provider
or go to this address on the Internet
for more information
www.siemens.com/
mobilephonescustomercare
in the "FAQ" section.
Authentication
Activate or deactivate encrypted
dial-up (CSD connections only) for
Internet access.
MMS, WAP ap-
Fax/data
Send voice/fax
Set this function on the phone before
transmission so that you can switch
from voice mode to fax mode.
Rec. voice/fax
Start the required communication
program on your PC and activate
the function on the phone during
the call (the PC will take over the
connection).
Rec. fax/data
The call is signalled by a special ring-
tone and the type of call (fax or data)
is displayed in the phone display. Now
start the communication program on
your PC to receive the fax/data.
Security
¢ ¢
Security
C
T
¢
Select function.
Auto key lock
The keypad is locked automatically
if no key has been pressed for one
minute in standby mode. This pre-
vents the phone from being used
accidentally. However, you can still
be called and you can still make an
emergency call.
Additional information
Block/unblock in standby mode. In each
case:
Press and hold.
#
b
b
b