Charge Battery - Siemens CF62 Operating Instructions Manual

Charge battery

The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains
power socket and charge for at least
two hours.
Display when charging is in progress
h
During charging.
If is activated for
Dynamic light
ging (page 43) the middle two LEDs
flash slowly to show that the charg-
ing process is in progress. When the
battery is fully charged, these LEDs
switch off.
Charging time
An empty battery is fully charged
after about 2 hours. Charging is only
possible within a temperature range
of +5 °C to +40 °C. If the tempera-
ture rises/falls 5 °C above/below this,
the charge symbol flashes a warn-
ing. The mains voltage specified
on the power supply unit must
not be exceeded (Operating time,
page 65).
Charge icon not visible
If the battery has been discharged
fully the charge icon is not immedi-
ately visible when the power supply
unit is plugged in. It will appear after
up to two hours. In this case the bat-
tery is fully charged after 3-4 hours.
Only use the power supply unit provided!
Display while in service
Charge level display during opera-
tion (empty-full):
A beep sounds when the battery is
nearly empty. The charge level of the
battery is only displayed correctly
after an uninterrupted charging/dis-
charging cycle. You should therefore
Char-
not remove the battery unnecessarily
and where possible not terminate the
charging process early.
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock will be reset.
Getting started
a d g
9