Installing The Lithium Batteries - Sharp Viewcam VL-Z7U Operation Manual

Preparation
Installing the Lithium
Batteries
Installing the Memory Battery
The supplied CR 1216 type lithium battery is
used to store the memory of the date and
time settings.
1
Make sure that the Power switch is
set to OFF.
2
Open the LCD monitor to a 90° angle
to the camcorder body.
3
Slide the battery release in the
direction of the arrow, then take the
battery pack out.
Battery release
4
Pull out the lithium battery cover in
the direction of the arrow.
12
5
Insert the smaller lithium battery into
the compartment with the H side of
the battery facing out.
6
Close the lithium battery cover firmly
until it clicks into place.
Removing the Memory
Battery
Perform steps 1 and 4
above, then lift out the
battery by using a pointed
object such as the tip of a
ballpoint pen.
Lithium
battery cover
CR 1216 type
lithium battery