Freezing Images; Presetting Remote Control Function - Sharp AQUOS LC-57D90U Operation Manual

Other viewing options

Freezing images

You can display two same-sized pictures – one moving
and one still.
Press FREEZE.
1
• A moving image displays on the left screen and
a still image displays on the right screen. The
still image is one frame captured from a moving
image at the moment you press FREEZE.
Update the still image by pressing ENTER.
2
• Each time you press ENTER, the image on the
right screen updates.
Press FREEZE to exit still image.
3
NOTE
• This function does not work in INPUT 4 (HDMI) and INPUT
5 (DVI-I).
• When this function is not available, "No displaying still
image available" will display.
• The still image is automatically erased after 30 minutes.
• If you are using the freeze function and a broadcast
activates the V-CHIP BLOCK, the freeze function will be
cancelled and a V-CHIP BLOCK message will appear.

Presetting remote control function

You can operate the connected AV products (AV
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD)
using the presetting manufacturer function of your
remote control unit.
Presetting manufacturer codes
FREEZE
1
2
3
4
Press FUNCTION until the LED for your
device lights up.
After the LED for your device lights up, press
FUNCTION and DISPLAY at the same time
to enter the code registration mode. The LED
will blink.
Press 0 – 9 to enter the manufacturer code.
(See page 62.)
• Preset mode is finished once the LED no longer
lights up.
After registering the code, the LED will stop
blinking, and then turn off after one second.
(If you perform an incorrect operation, the
LED will blink quickly then turn off.)
61