Download  Print this page

Auto Installation - Sharp 32JF-77H Operation Manual

Sharp 32jf-77h: operation manual.
Hide thumbs

Advertisement

Table of Contents

Auto Installation

Auto Installation System
Your television set is provided with an Automatic Installation System, which makes Installation easier.
This new system is activated when you turn on the TV for the first time.
Note:
You may not have to follow this procedure if it has already been done for you at the establishment where you
purchased your TV. If this is the case, go on to the section entitled "Switching ON" (page 13).
Procedure:
1. Put batteries into the remote control, as shown on page 3.
2. Connect the aerial jack into the aerial input terminal on the rear side of your TV, as shown on page 6.
3. Connect the TV power cable to a 220 ~ 240 V system, as shown on page 10.
4. Press the main power button (®), on the front of the TV set, to
start the "AUTO INSTALLATION". The orange power indicator will
light.
5. The "AUTO INSTALLATION" message will appear on your TV
screen followed by a diagram of typical connections.
"AUTO INSTALLATION" message
6. Press the MENU button b on the handset to cancel the AUTO
INSTALLATION or any other button to continue.
The TV is ready to preset automatically all local channels for you.
If the TV is being used with a VCR, turn on the VCR and play back
a pre-recorded tape. The signal from the RF terminal of your VCR
is assigned to a TV channel.
7. Follow the instructions on the screen, to start Auto Channel
Preset.
Auto Channel Preset
The TV will go through the following steps automatically and
sequentially:
Automatic Channel Sorting System (ACSS): The TV set SEARCHES
FOR FREQUENCIES, memorises the channels found, and sorts them
(according to technical criteria) from Pr-01 of the TV, to a maximum of
99 programmes.
Note:
This tuning process may take several minutes to perform.
Stored programmes Menu
When the AUTOMATIC SEARCH has been completed, the "STORED
PROGRAMMES" menu will appear on screen and you can change the
order of the channels and change or give the channels a four-letter
name.
If you wish to rename the channels, or change the order, refer to the
chapter -Stored programmes- (page 12).
If you wish to go out of the menu, press the BLUE button
If you need to repeat the "AUTO INSTALLATION", read on -TV
Channel Setting- (page 36).
To continue
"AUTO INSTALLATION" message
Searching
Automatic searching and sorting. Please, wait.
Stored programmes Menu
.
EDIT NAME
EDIT NAME
11
Power indicator
Main power button
VCR
Press the menu button to cancel.
EXIT
SORTING
DELETE
DELETE
EXIT
SORTING

Advertisement

Table of Contents

   Related Manuals for Sharp 32JF-77H

Comments to this Manuals

Symbols: 0
Latest comments: