Check the 3M
TM
Ranger
TM
system website to ensure you have the most recent version of this document.
10 English
Instructions for Use
Preparation and setup of the Ranger blood/fluid
warming unit
1. Attach the Ranger blood/fluid warming unit to the I.V. pole.
Tighten the pole clamp securely.
CAUTION:
medical device damage:
• Clamp the Ranger blood/fluid warming unit to
2. Slide the cassette into the slot in the warming unit. The
cassette can only fit into the device one way.
3. Prime the warming set. For more information about priming the set, refer to instructions
provided with the warming sets.
4. Place the bubble trap in the holder.
5. Plug the power cord into an appropriate outlet. Turn the unit ON. In a few seconds the
alphanumeric display will illuminate. It takes less than two minutes to warm up to the 41°C set
point temperature.
6. Begin infusion. When infusion is completed, remove the warming set and discard according to
institutional protocol.
To reduce the risks associated with impact and facility
an I.V. pole with a minimum 14" (35.6 cm) radius
wheelbase and at a height no higher than 44" (112
cm).
www.rangerfluidwarming.com
3M
™
Ranger
™
Blood/Fluid Warming System
44"
14" (35.6 cm)
(112 cm)
reorder #202457B