Setting Up The Projector Network Environment; Network Settings On The Computer - Sharp Notevision PG-C355W Setup Manual

Setting up the Projector Network Environment

This section describes the basic procedure for using the projector via the network.
If the network is already constructed, the projector's network settings may need to be changed. Please
consult your network administrator for assistance with these settings.
You can make network settings both on the projector and on the computer. The following procedure is for
making settings on the computer.

Network settings on the computer

1.
Connecting the projector to a computer
Connect a LAN cable (Category 5, cross-over type) between the computer and projector.
2.
Setting an IP address for the computer
Adjust the IP settings of the computer to enable one-to-one communications with the projector.
3.
Setting up a network connection for the projector
Adjust the projector network settings to conform to your network.
• Microsoft ® , Windows
United States and/or other countries.
• PJLink is a registered trademark or an application trademark in Japan, the United States and/or other
countries/regions.
• All other company or product names are trademarks or registered trademarks of their respective compa-
nies.
-18
LAN cable
(commercially available)
® and Windows Vista ® are registered trademarks of Microsoft Corporation in the
Page 19
Temporarily change
the computer's IP
address.
Pages 20, 21
Use Internet Explorer
(version 5.0 or later)
to make various
projector settings.
Pages 22, 23