Copier Trouble; Misfeed Removal - Sharp AL-1451 Operation Manual

6

COPIER TROUBLE?

This chapter describes misfeed removal and troubleshooting.

MISFEED REMOVAL

When the misfeed ( ) indicator blinks or
of a misfeed.
If a misfeed occurs when using the SPF, a number may appear in the display after a minus
sign. This indicates the number of the originals that must be returned to the document feeder
tray after a misfeed. Return the required number of originals. Then this number will disappear
when copying is resumed or the clear (
When the SPF misfeeds an original sheet, the copier will stop and the SPF misfeed ( ) indicator
will blink, while the misfeed (
see "E Misfeed in the SPF" on page 37.
Open the side cover while pressing the side cover open button.
1
Check the misfeed location. Remove the misfed paper following the instructions for
2
each location in the illustration below.
If blinks in the display, proceed to "A Misfeed in the paper feed area". (p. 34)
If the misfed paper is seen from
this side, proceed to "C Misfeed
in the transport area". (p. 35)
blinks in the display, the copier will stop because
) key is pressed.
) indicator will remain off. For a misfeed of originals in the SPF,
If paper is misfed here, proceed to "B
Misfeed in the fusing area". (p. 34)
If paper is misfed here, proceed to "A
Misfeed in the paper feed area". (p. 34)
6
33