Removing Power Supplies; Installing Power Supplies - Check Point 12000 Getting Started Manual

Replacing Power Supplies

Removing Power Supplies

This section describes how to remove a power supply or placeholder unit from the appliance.
To remove a power supply unit:
1. If the alarm sounds, press the red alarm button to the right of the power supply.
The alarm stops.
2. Remove the power cord from the power supply unit.
3. Engage and hold the release lever on the power supply or placeholder unit.
4. Pull the extraction handle to remove the power supply or placeholder unit.

Installing Power Supplies

This section describes how to install a power supply or placeholder unit into the appliance.
To install a replacement power supply:
1. Insert the power supply or placeholder unit into the power supply slot.
2. Push the power supply or placeholder unit until the release lever clicks.
3. Insert the power cord into the power supply socket. Make sure that the green LED is
illuminated.
Page 44
CP_12000_Appliances_GettingStart44 44 CP_12000_Appliances_GettingStart44 44
Note - Remove the power supply unit with the extraction handle to
prevent any possible damage.
20 July 2011 4:04:33 PM 20 July 2011 4:04:33 PM