Dv Record Audio; Auto Chapter; Disc; Disc Initialize - Sanyo DRW-1000 Instruction Manual

Before Operating (Continued)

DV Record Audio

Set this if you have a camcorder using 32kHz/12-bit
sound connected to the front panel DV IN jack.
Some digital camcorders have two stereo tracks for
audio. One is recorded at the time of shooting. The
other is for overdubbing after shooting.
On the Audio 1 setting, the sound that was recorded
while shooting is used.
On the Audio 2 setting, the overdubbed sound is used.
DISC Record Mode
VCR Record Mode
DV Record Audio

Auto Chapter

Auto Chapter
When recording in Video Mode, chapter markers are
put at specified intervals. You can change this interval
to 3 minutes, 5 minutes, or 10 minutes. To select "Not
Use", switch the automatic chapter marking off and
select the No Separation setting.
DISC Record Mode
VCR Record Mode
DV Record Audio
Auto Chapter
ote
Chapter markers' interval time may not be accurate.
24

DISC

Disc Initialize

• If you load a blank DVD-R disc, it will always be ini-
• If you load a blank DVD-RW disc, you will be prompt-
• If you load a DVD-RW that has already been used,
Audio 1
Audio 2
Select
Prev.
1 1
2 2
3 3
4 4
5 5
Not Use
3 Min
6 6
5 Min
10 Min
Prev. Select
7 7
8 8
9 9
If you want to change the disc format, everything
recorded on the disc will be erased.
tialized in Video mode, which allows the disc to be
played in most standard DVD players.
ed to initialize the disc in Video mode (for maximum
compatibility) or VR mode (to enable advanced edit-
ing features).
you can change between Video mode and VR mode
by erasing the disc using the DISC Initialize feature.
DISC Initialize
DISC Finalize
DISC Name
DISC Protect
Press SETUP.
The Setup menu appears.
Use v / V to select the DISC option.
While the DISC option is highlighted, press B to
move to the second level.
Use v / V to select the DISC Initialize option.
Press B to move to the third level.
The Start icon is highlighted.
Press ENTER.
The Disc Initialize menu appears.
Disc Initialize
Select mode.
VR Mode
Use b / B to select a desired DISC Initialize
Mode (VR Mode or Video Mode) then press
ENTER.
Use b / B to select OK, and press ENTER.
It takes a few moments to initialize the disc.
Press ENTER.
Caution
Start
Prev. Select
Video Mode