Network Commands - Murata Hn-210 Manual

Network Commands

Network commands are used to set up a HopNet network and to set radio addressing
and configuration.
Command
wb[?|0|1]
wd[?|0-3f]
(base only)
wg[?|0|1]
(remote only)
wn[?|0-3f]
wp[?|0|1]
wr?
(remote only)
wu[?|0|1]
dx[?|0-FF]
(remote only)
Set Transceiver Mode
Sets modem operation as either base station or remote. Default is remote.
Set Default Handle
This handle will override the automatic handle assignment by the base station. When
specified for the base, the default handle determines which remote it will address
when transparent protocol mode is in effect. When 3FH is specified for the base,
broadcast mode is entered.
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2004
HN-210/210X 01/13/17
Description
Set Transceiver Mode
0 = remote (default)
1 = base station
Set Default Handle
Used to override automatic handle assignment by the base station
30 = default
Enable Global Network Mode
0 = Link only to hop pattern specified by wn parameter (default)
1 = Link to any hop pattern, regardless of wn parameter
Set Hopping Pattern (Network Number)
0 = default
Set Transmit Power
0 = 10mW
1 = 100mW (default)
Read Receive Signal Strength
Set Point-to-Point Direct Mode
0 = Multipoint mode (default)
1 = Point-to-point direct mode
Set Range optimization
0 = default
40 of 58
Downloaded From Oneyac.com
HN210
www.murata.com