Murata HN-210 Manual page 27

Set the Frequency Operating Range
( ) by clicking on the drop-down
pe
menu and making a selection. ¹
Select the Distance from Base (
drop down and make a selection.
Set Redundant Transmit (
selecting either ARQ enabled or ARQ
disabled.
Choose the type of Escape Sequence (
Unlimited times.
¹ The selections in this field will change depending on the frequency band the radio operates in. For 2.4GHz
radios, selecting one of the 802.11b bands in which to operate, the HopNet radio can be used in locations with
802.11b networks without causing interference with those networks. If there are no 802.11b networks present, it
is recommended that the radio be set to operate in the entire band which is the default. For 900MHz radios, there
will only be two bands to select.
² The Radio Power Setting controls how much power is used to transmit data. Unless the HopNet radio operates in
the 2.4GHz band and is being used in the European Union (EU) this setting should be left at the default High
Power. Because of the built-in antenna of the HopNet radio, the 10mW power setting must be used when
operating in an EU country.
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2004
HN-210/210X 01/13/17
Set Radio Power Setting (
clicking on a selection. ²
Note: This list will change depending
on which radio is being used.
Set Maximum Number of Remotes
)
dx
( ) from1 to 62.
pn
) by Choose to have the Banner Display
px
( ) or not by selecting Banner
zb
disabled or Banner enabled.
) by selecting Once after reset or
zc
27 of 58
Downloaded From Oneyac.com
HN210
) up by
wp
www.murata.com