Murata HN-210 Manual page 22

When the radio is linked to another radio, a communications test can be run by
clicking on the Send Data button (shown below) on both radios. The remote radio's
Transmit Data window (above left) will display the message, "This is a test message
from the Base radio", which will repeat until the Stop button is pressed (on the base
radio's HN Wizard main screen). The base radio's Transmit Data window (above
right) will display the message, "This is a test message from the Remote radio" which
will repeat until the Stop button is pressed (on the remote radio's HN Wizard main
screen).
Send Data
The Send Data button (shown below) initiates the transmission of data.
Default
The Default button (shown above) returns all parameters to Factory settings.
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2004
HN-210/210X 01/13/17 22 of 58
Downloaded From Oneyac.com
HN210
www.murata.com