Murata HN-210 Manual page 20
Outdoor base remote
Table of Contents
Modbus mode is selected to prevent Modbus errors from occurring due to inter-
character gaps that are too long. Refer to the section, Modbus Operation for details on
this mode.
Network Number
This parameter is also known as Set Hopping and is the same command as
to "Configuration Commands" section for additional information on commands.) By
using different network numbers or "hopping patterns", nearby or co-located
networks can avoid interfering with each other's transmissions.
BaudRate
Also known as Set Data Rate Divisor (command
rate between the modem and the host.
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2004
HN-210/210X 01/13/17
20 of 58
Downloaded From
Oneyac.com
) this parameter sets the serial bit
sd
HN210
.(Refer
wn
www.murata.com
Table of Contents
Need help?
Do you have a question about the HN-210 and is the answer not in the manual?