Modem Command Summary - Murata Hn-210 Manual

Modem Command Summary

Serial Commands
sd[?|00..ff]
sp[?|00..14]
Network Commands
wb[?|0|1]
wd[?|0..3f]
wn[?|00..3f]
wg[?|0|1]
wp[?|0|1]
wr?
wu[?|0|1]
dx[?|0..ff]
Protocol Commands
pe[?|0..8]
ph[?|00..fe]
pl?
pn[?|01..3e]
pk[?|00..d4]
pr[?|00..ff]
pt[?|00..ff]
pv[?|0|1]
pw[?|00..34]
px[?|0|1]
Status Commands
zb[?|0|1]
zc[?|0..2]
zh?
zm?
zl?
zp[?|0..4]
zq[?|0|1]
z>
Memory Commands
m0
m<
m>
m!
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2004
HN-210/210X 01/13/17
Set Data Rate Divisor
Set Protocol Mode
Set Transceiver Mode
Set Default Handle (base only)
Set Hopping Pattern
Enable Global Network Modes (remote only)
Set Transmit Power
Read Receive Signal Strength (remote only)
Set Point-to-Point Direct Mode
Set Range Optimization (remote only)
Set Alternative Frequency Band
Set Hop Duration (base only)
Get Maximum Data Length
Set Maximum Number of Remotes (base only)
Set Minimum Data Length
Set Packet Attempts Limit
Set Data Transmit Delay (remote only)
Set Slot Assignment Mode (base only)
Set Base Slot Size (base only)
Set ARQ Mode
Banner Display Disable
Set Escape Sequence Mode
Read Factory Serial Number High Byte
Read Factory Serial Number Middle Byte
Read Factory Serial Number Low Byte
Set Duty Cycle(base only)
Enable Low Power Acquisition (remote only)
Exit Modem Control Mode
Recall Factory Defaults
Recall Memory
Store Memory
Display Modified Settings
49 of 58
Downloaded From Oneyac.com
HN210
www.murata.com