Turning Your Phone On And Off; Battery And Charger - Sanyo Juno User Manual

Turning Your Phone On and Off

Turning Your Phone On
Press and hold
Once your phone is on and finds a signal, it
automatically enters standby mode – the phone's idle
state. At this point, you are ready to begin making and
receiving calls.
If your phone is unable to find a signal after 15 minutes
of searching, a Power Save feature is automatically
activated. When a signal is found, your phone
automatically returns to standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also
initiate a search for Sprint service by pressing any key
except numbered keys.
Tip The Power Save feature conserves your battery
power when you are in an area where there is no
signal.
14 2A. Phone Basics
.
Turning Your Phone Off
Press and hold for two seconds until you see the
powering-down animation on the display screen.
Your screen remains blank while your phone is off
unless the battery is charging.

Battery and Charger

WARNING Use only Sprint-approved or Kyocera-
approved batteries and chargers with your
phone. The failure to use a Sprint-approved
or Kyocera-approved battery and charger
may increase the risk that your phone will
overheat, catch fire, or explode, resulting in
serious bodily injury, death, or property
damage.
Sprint-approved or Kyocera-approved batteries and
accessories can be found at Sprint Stores or through
Kyocera; or call 1-866-866-7509 to order. They're also
available at
www.sprint.com
.