ENABLE & DISABLE VOICE PROMPT
1. Turn your vehicle's ignition ON
2. Go to Bluetooth source (SAT1)
3. Disable the Bluetooth function from your phone's setting
4. Wait 5 seconds, press the SEEK ▶ or ▲ button to ENABLE.
Press ◀ SEEK or ▼ to DISABLE
5. Enable your phone's Bluetooth function and reconnect to
the BT45. The feature will stay disabled or enabled until you
perform the above steps again.
•
The above steps will enable/disable both the voice
prompt and the caller # announcement features
AUX PORT
1. You will need a 3.5mm to headphone jack cable (not
included in this package)
2. Go to SAT1, then press & hold the PRESET-6 button for up to
3 seconds to access the audio device connected to the AUX
port
3. Short press the PRESET 4 button to switch back to Bluetooth
audio source
•
Remember to turn the volume from the audio device to MAX
first then use the radio/steering wheel's volume control to
adjust to the desired level
USB CHARGING PORT
•
USB charging cable is not included in this package
•
Maximum charging output: 2.1 amps at 5 volt
13