Operating Instructions - Lights; Operating Instructions - Audio - High tech health Transcend TR-2 Owner's Manual

OPERATING INSTRUCTIONS – LIGHTS
Your sauna will default to the white reading light when your keypad turns on.
To change the colors of the light, press the light bulb button on the keypad. Pressing it will
cycle through various preset colors. The last preset before it cycles back to the white light
is a setting the loops through all of the colors.
To turn the light off, hold down the light bulb button for a few seconds.
OPERATING INSTRUCTIONS – AUDIO
Your sauna is equipped with Bluetooth so that you can stream music from a phone or
tablet. Alternatively, you can directly connect a source of audio.
To use any audio, you must turn the power on to the audio system using the switch in the
ceiling of your sauna.
To stream Bluetooth audio, use your phone or tablet to connect to "IR Sauna" from its
Bluetooth settings. You will adjust the volume from your phone or tablet.
To connect an audio source directly to your sauna, use the included audio cable. Connect
one end of this cable to the audio box in the roof of your sauna. You can access the audio
box by lifting the door at the top of your sauna in the front right corner. Connect the cable
to the available jack at the front of the black box inside. Connect the other end of the
cable to a headphone jack or line-out connection from phone/tablet/or other electronics.
When this cable is connected to the sauna, Bluetooth is automatically disconnected.
There is an accessory shelf separately available for purchase that can hang from the
front right corner of the top of your sauna to hold your phone or tablet device while it is
connected to your sauna.
© 2022, 2023 High Tech Health International, Inc.
36
MTR23-20230209A