Breakdown Of Parts - Wayne-Dalton TOROQUEMASTER PLUS Installation Instructions And Owner's Manual

NOTE: The illustrations shown on this page are general
representations of the door parts. Each specific door
models may have unique variations.
J2.
J7.
J5.
J6.
J3.
F2.
A2.
F1.
C1.
A1.
B1.
D2.
B2.
D1.
C1.
I3.
I5.
A. FLAG ANGLES (AS REQUIRED):
A1. Quick Install (Q.I.) Flag Angles
A2. Fully Adjustable (F.A.) Flag Angles
B. JAMB BRACKETS (AS REQUIRED):
B1. Quick Install (Q.I.) Jamb Brackets
B2. Fully Adjustable (F.A.) Jamb Brackets
C. TRACK ROLLERS (AS REQUIRED):
C1. Short Stem Track Rollers
C2. Long Stem Track Rollers
D. GRADUATED END HINGES:
D1. Single Graduated End Hinges (S.E.H.), Anti-Pinch
D2. Double Graduated End Hinges (D.E.H.), Anti-Pinch
E. STACKED SECTIONS:
E1. Top Section
E2. Intermediate(s) Section
E3. Lock Section
E4. Bottom Section
F. TOP FIXTURES (AS REQUIRED):
F1. Top Fixture Bases - (L - Shaped)
F2. Top Fixture Slides - (L - Shaped)
G. STRUT(S) (AS REQUIRED):
G1. Strut (U - shaped)
H. DRAWBAR OPERATOR BRACKET (FOR TROLLEY OPERATED DOORS):
H1. Drawbar Operator Bracket

BREAKDOWN OF PARTS

J7.
J1.
H1.
E1.
E2.
I1.
E3.
K1.
C2.
A1.
A2.
J5.
J4.
C1.
F2.
F1.
G1.
B1.
Top of vertical
track
B2.
3rd hole
set
I4.
E4.
2nd
hole set
I6.
1st hole
set
I. TRACKS (AS REQUIRED):
I1. Left Hand Horizontal Track Assembly
I2. Right Hand Horizontal Track Assembly
I3. Left Hand Vertical Track
I4. Right Hand Vertical Track
I5. Left Hand Riveted Vertical Track Assembly
I6. Right Hand Riveted Vertical Track Assembly
J. TORQUEMASTER PLUS
J1. Center Bracket Bushing Assembly
J2. TorqueMaster
J3. Left Hand End Bracket (Double Springs Only)
J4. Right Hand End Bracket (Disconnect Cable Guide)
J5. Left Hand And Right Hand Cable Drum Assemblies
J6. Idler bracket (Single Spring Only)
J7. Left Hand And Right Hand Drum Wraps (Optional)
K. REAR BACK HANGS:
K1. Left Hand And Right Hand Rear Back Hang Assemblies
5
I2.
K1.
Top of vertical
track
3rd
B1. (Quick
hole set
Install
Feature)
2nd
hole set
Top
hole
Middle
hole
1st
hole set
Bottom
hole
SPRING ASSEMBLY:
®
Spring Tube (Single Or Double Springs)
®
B2. (Fully
Adjustable
Feature)
Lower hole
of hole/
slot pattern