Turning On the Power
Once the connections have been completed, turn on power to your various devices in the
order specified. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1.
Before turning on the power, check the following points.
- Have connections with external devices been made correctly?
- Has the volume of the DR-770 and the connected amp system been turned to the
minimum position?
2.
Turn on the POWER switch located on the rear panel of the DR-770.
fig.01-02a
POWER
3.
Turn on the power of your amp system.
4.
While striking the pads, rotate [VOLUME] to adjust the volume of the
DR-770.
fig.01-03a
Adjust the volume of the connected amp system to an appropriate level.
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
NOTE
required before the unit will operate normally.
Turning Off the Power
1.
Before you turn off the power, check the following points.
- Have the volume controls of the DR-770 and the connected amp system been turned to
the minimum position?
2.
Turn off the power of the amp system.
3.
Turn off the power of the DR-770.
14
AC IN 14V
PHONES
PEDAL SW
700mA
ON
OFF
OUT
MIDI
IN
USE BOSS BRC
ADAPTOR ONLY
On
Off
INDIVIDUAL
OUTPUT
R
L(MONO)
MADE IN JAPAN