Download  Print this page

Operation; Remote Punch Eq (option); Punch Eq; Adjusting Crossover Frequency - Rockford Fosgate Punch P1000-1bd Installation And Operation Manual

Mono amplifiers.
Hide thumbs

Advertisement

Table of Contents
I
NSTALLATION
O
PERATION

REMOTE PUNCH EQ (Option)

NOTE:Previous (prior to 2007) Punch Bass and Para-Punch
remotes will not work with these amplifiers.
NOTE: Use the instructions that came with the remote for
a variety of mountings that fit your preference.
Quick Install
1.
Using the screws supplied, install the mounting clip.
2.
Slip the remote onto the mounting clip until it snaps
into place.
3.
Route and connect the cable to the remote and
amplifier.

Operation

6.
Operation works the same as Punch EQ, see below.
NOTE: Connecting the optional remote overrides the Punch EQ control on the amplifier.
CAUTION:Overexcursion and subsequent damage may occur at high levels of boost.

PUNCH EQ

This works along with the crossover switch on the amplifier.
When set to Low-Pass (LP) operation, this is a variable Bass Boost.
When set to High-Pass (HP) operation, this is a variable Mid-Bass and Treble Boost (P300-1/P400-1).
When set to All Pass (AP) operation, both the Bass and Treble frequencies are boosted (P300-1/P400-1).
Set this to your personal preference while listening to the system.
NOTE: Connecting the optional remote overrides the Punch EQ control on the amplifier.
ADJUSTING CROSSOVER FREQUENCY (P300-1/P400-1)
Placing the crossover switch in the HP position sets the amplifier to the High Pass mode,
enabling frequencies above the cut-off point to pass, adjustable between 50-500Hz.
Placing the crossover switch in the AP position sets the amplifier to the All Pass mode,
preventing any crossover adjustment, allowing all frequencies to pass.
Placing the crossover switch in the LP position sets the amplifier to the Low Pass mode,
enabling frequencies below the cut-off point to pass, adjustable between 50-500Hz.
Turn the crossover adjustment knob all the way down.With the system playing, turn the
crossover adjustment knob up slowly until the desired crossover point is achieved.
ADJUSTING CROSSOVER FREQUENCY (P500-1bd/P700-1bd/P1000-1bd)
The crossover frequency can be adjusted between 35-250Hz.The crossover is set to LP (Low Pass)
operation only.
Turn the crossover adjustment knob all the way down.With the system playing, turn the crossover
adjustment knob up slowly until the desired crossover point is achieved.
8

Advertisement

Chapters

Table of Contents

   Also See for Rockford Fosgate Punch P1000-1bd

   Related Manuals for Rockford Fosgate Punch P1000-1bd

This manual is also suitable for:

Punch p300-1Punch p400-1Punch p500-1bdPunch p700-1bd

Comments to this Manuals

Symbols: 0
Latest comments: