Download  Print this page

Remote Punch Bass; Operation; Adjusting Gain; Adjusting Crossover Frequency - Rockford Fosgate Pro Series bd1001P Installation And Operation Manual

Class bd mono amplifiers.
Hide thumbs

Advertisement

Table of Contents
I
NSTALLATION

REMOTE PUNCH BASS

Mounting and installation
1. Find a location, either under the dash or
near the center console, that gives easy
access to the remote.
2. Using the screws supplied, install the
mounting clip with the tabs towards
the back.
3. Route the cable for the remote and
connect to both the remote and
amplifier.
4. Slip the remote onto the mounting clip
until it snaps into place.
5. Place the decal onto the remote and use
the nut to hold the decal in place. Do
not over tighten nut.
6. Install the knob onto the remote.
O
PERATION

ADJUSTING GAIN

To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up until
distortion is audible and then turn it down a bit until the distortion is inaudible. This will be about two thirds
all the way up on most source units. Next, turn the amplifier gain setting until once again distortion is audible
and then back it down until the distortion is inaudible. Rockford Fosgate source units do not distort, so the
volume can be used at maximum setting.
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.

ADJUSTING CROSSOVER FREQUENCY

The crossover frequency can be adjusted between 50-250Hz. The crossover is set to LP (Low Pass) operation
only.
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover adjustment
knob up slowly until the desired crossover point is achieved.
SUBSONIC FILTER
Placing the switch to "ON" engages a subsonic filter limiting the amount of low frequency information going
to the woofer. Set this to your personal preference while listening to the system one way, then the other.
8
Mounting
Clip
Decal
Knob
Nut

Advertisement

Chapters

Table of Contents

   Related Manuals for Rockford Fosgate Pro Series bd1001P

This manual is also suitable for:

Pro series bd1501pPro bd1001pPro bd1501p

Comments to this Manuals

Symbols: 0
Latest comments: