Lowenstein Medical LM Flow 100 Brief Instructions For Use

Hide thumbs Also See for LM Flow 100:

LM Flow 100 Brief Instructions for Use

1. Installation

Connect the

nozzle fitting to the

water chamber.

Connect the

heated tube system.

To insert the

water chamber, press

the lock with the

bottom of the water

chamber and slide the

water chamber onto

the heating plate until

the lock engages.

Connect the

oxygen source (not

necessary if no

additional oxygen is

required).

Connect the

water bag/water bottle.

Connect the

LM Flow 100 to

power.

Check the water

level in the water

chamber.

Table of Contents

Do you have a question about the LM Flow 100 and is the answer not in the manual?

Page 1 LM Flow 100 Brief Instructions for Use 1. Installation Connect the Connect the Check the water To insert the nozzle fitting to the water bag/water bottle. level in the water water chamber, press water chamber. the lock with the chamber.
Page 2 2. Parameter setting Select the Set the required Adjust the nasal Press the parameters using the parameters (O , flow, Start/Stop key for cannula. touchscreen. temperature) using the three seconds to start touchscreen/encoder. the therapy. 3. At the end of therapy Disconnect/shut Press the Remove the tube system and disconnect the power.