ION Pathfinder Go User Manual page 9

Hide thumbs Also See for Pathfinder Go:

Stereo-Link

: Syncing Two Speakers

Tip: Pathfinder

Go can sync audio with other Pathfinder

Pathfinder

320°.

1. Be sure to disconnect Bluetooth devices before attempting to pair speakers using Stereo-

Link

. Press and hold the Bluetooth button to do this.

2. Press and hold the Link button on each Pathfinder

heard and the link icon in each display will flash while a link is being established. Please

allow 10 to 30 seconds for the speakers to link.

Note: Speakers should be within 50' (15 m) of each other to properly link. The closer the

speakers are, the faster they will link.

Note: To exit Stereo-Link

3. Once the speakers are linked, the Link icon will be lit solid on both units.

4. Select which unit will be the "primary" speaker by pressing and releasing the Bluetooth

button on that unit.

5. Navigate to your device's Bluetooth settings menu and select Pathfinder Go to connect.

When the connection is successful, you will hear "Bluetooth Connected" from the primary

speaker (if voice prompts are enabled). When Bluetooth audio playback begins, you

should hear it through both speakers. The primary speaker will play the left channel while

the secondary speaker plays the right channel. Playback controls are active on both

speakers.

Note: Radio, Aux, and USB modes will be disabled when Stereo-Link

6. To exit Stereo-Link

disconnected" from the primary speaker to indicate the link has been broken (if voice

prompts are enabled).

mode, double-press the Link button again.

mode, double-press the Link button. You will hear "Bluetooth

Go speakers or with the ION

speaker. A beeping sound will be

is active.

Table of Contents