Table of Contents
Advertisement
Quick Links
52059455
1.800.561.8187
INSTRUCTION MANUAL
MANUAL DE INSTRUCCIONES
MANUEL D'INSTRUCTIONS
Read and understand all of the instructions and safety information in this
manual before operating or servicing this tool.
Lea y entienda todas las instrucciones y la información sobre seguridad
que aparecen en este manual, antes de manejar estas herramientas o
darles mantenimiento.
Lire attentivement et bien comprendre toutes les instructions et les
informations sur la sécurité de ce manuel avant d'utiliser ou de procéder à
l'entretien de cet outil.
© 2011 Greenlee Textron Inc.
www.
TG-1000
Infrared Thermometer
Termómetro infrarrojo
Thermomètre infrarouge
.com
information@itm.com
4/11
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Textron GREENLEE TG-1000
Summary of Contents for Textron GREENLEE TG-1000
- Page 1 Lire attentivement et bien comprendre toutes les instructions et les informations sur la sécurité de ce manuel avant d’utiliser ou de procéder à l’entretien de cet outil. 52059455 © 2011 Greenlee Textron Inc. 4/11 1.800.561.8187 information@itm.com www. .com...
-
Page 2: Purpose Of This Manual
Keep this manual available to all personnel. Do not discard this product or throw away! F All specifications are nominal and may change as design improvements occur. Greenlee Textron Inc. shall not be liable for damages resulting from misapplication or misuse of its products. -
Page 3: Important Safety Information
TG-1000 Important Safety Information SAFETY ALERT SYMBOL This symbol is used to call your attention to hazards or unsafe practices which could result in an injury or property damage. The signal word, defined below, indicates the severity of the hazard. The message after the signal word provides information for preventing or avoiding the hazard. - Page 4 Important Safety Information Electric shock hazard: Do not open the case, except for the battery compartment. Before opening the case, release the trigger and shut off the unit. Failure to observe these warnings could result in severe injury or death. This unit is not intended for medical applications.
- Page 5 TG-1000 Important Safety Information Temperature readings will be inaccurate on highly reflective objects. Temperature readings will be inaccurate on objects if emissivity is not adjusted properly. Follow masking and emissivity adjustment procedures. Allow 30 minutes for the unit to adjust to large changes in ambient temperature; inaccurate readings can result.
-
Page 6: Display Icons
Identification 1. Display 2. Decrease button and °C/°F selector 3. Mode selector °C/°F Lock Mode 4. Increase button and Lock button 5. Trigger 6. Battery compartment door 7. Lens 8. Laser Display Icons 10. Hold mode indicator 11. Full battery indicator °C °F 11A. -
Page 7: Using The Features
TG-1000 Using the Features Basic Features To turn the laser on or off: Press and hold the trigger, and then momentarily press the °C/°F button. To turn the backlight on or off: Press and hold the trigger, and then momentarily press the Lock button. - Page 8 Distance from Target Thermometers measure the surface temperature of an object by sensing its emitted, reflected, and transmitted energy. The sensor collects this energy from the area being measured (spot size). The spot size varies as the distance to the target changes. The farther the distance from the area being targeted, the larger the spot size.
-
Page 9: Operation
TG-1000 Operation LASER RADIATION DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT LASER RADIATION–DO NOT STARE INTO BEAM CLASS II LASER PRODUCT Max. Output <1 mW, CAUTION–CLASS 2 Wavelength: 635-660 nm LASER RADIATION WHEN OPEN Complies with 21 CFR, Chapter 1, subchapter J 1. -
Page 10: Troubleshooting
Operation (cont’d) Troubleshooting Code Problem Action Thermometer has been exposed to rapid Allow at least 30 minutes for thermometer temperature change. to stabilize at new ambient temperature. Ambient temperature is outside operating Operate thermometer within limits in the limits (refer to “Specifications”). “Specifications”... -
Page 11: Typical Measurements
TG-1000 Typical Measurements Electronics Power Distribution HVAC Minimum width of line is 25 mm (1") for accurate reading Non-insulated line 1.800.561.8187 information@itm.com www. .com... - Page 12 Emissivity Emissivity is the ability of an object to emit infrared energy. Most objects or surfaces have an emissivity value of about 0.95. Some objects, such as polished or shiny metallic surfaces, may have much lower emissivity. Using an infrared thermometer to measure the temperature of such objects will produce inaccurate results.
- Page 13 TG-1000 Emissivity (cont’d) Common Emissivities Material Emissivity Material Emissivity Aluminum 0.30 Iron* 0.70 Asbestos 0.95 Lead* 0.50 Asphalt 0.95 Limestone 0.98 Basalt 0.70 0.94 Brass* 0.50 Paint 0.93 Brick 0.90 Paper 0.95 Carbon 0.85 Plastic** 0.95 Ceramic 0.95 Rubber 0.95 Concrete 0.95 Sand...
-
Page 14: Specifications
* For improved accuracy, allow unit 30 minutes to adjust to large change in temperature. Statement of Conformity Greenlee Textron Inc. is certified in accordance with ISO 9001 (2000) for our Quality Management Systems. The instrument enclosed has been checked and/or calibrated using equipment that is traceable to the National Institute for Standards and Technology (NIST). -
Page 15: Maintenance
TG-1000 Maintenance Electric shock hazard: Do not attempt to repair this unit. It contains no user-serviceable parts. Failure to observe this precaution may result in injury and can damage the unit. Battery Replacement 1. Slide the door down and away from the handle. 2. - Page 16 Lifetime Limited Warranty Greenlee Textron Inc. warrants to the original purchaser of these goods for use that these products will be free from defects in workmanship and material for their useful life, excepting normal wear and abuse. This warranty is subject to the same terms and conditions contained in Greenlee Textron Inc.’s standard one-year limited warranty.
Need help?
Do you have a question about the GREENLEE TG-1000 and is the answer not in the manual?
Questions and answers