GRE GWH15QD-K6DNA1A Service Manual page 28

Service Manual
2. FAN button
Press this button, Auto, Low, Medium-low, Medium, Medium-high, High speed can be circularly selected. After powered on,
Auto fan speed is default. Under DRY mode, Low fan speed only can be set up.
Low fan Medium-low fan
Note:
It's Low fan speed under Dry mode.
X-FAN function:Hold fan speed button for 2s in COOL or DRY mode, the icon "
operation for a few minutes in order to dry the indoor unit even though you have turned off the unit. After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed after the unit is stopped to avoid mould.
Having set X-FAN function on: After turning off the unit by pressing ON/OFF button indoor fan will continue running for a few
minutes. at low speed. In this period, Hold fan speed button for 2 s to stop indoor fan directly.
Having set X-FAN function off: After turning off the unit by pressing ON/OFF button, the complete unit will be off directly.
3. MODE button
Press this button, Auto, Cool, Dry, Fan, Heat mode can be selected circularly. Auto mode is default while power on. Under Auto mode, the
temperature will not be displayed;Under Heat mode, the initial value is 28°C( 82°F);Under other modes, the initial value is 25°C(77°F).
4. +/- button
Press " + " or " - " button once increase or decrease set temperature 0.1°C(°F).Holding " + " or " - " button, set temperature on remote
controller will change quickly . On releasing button after setting is finished, temperature indicator on indoor unit will change accordingly.
When setting TIMER ON, TIMER OFF or CLOCK, press " + " or " - " button to adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF
buttons) When setting TIMER ON, TIMER OFF or CLOCK, press " + " or " - " button to adjust time. (Refer to CLOCK, TIMER ON, TIMER
OFF buttons)
5. TURBO button
Under Cool or Heat mode, press this button can turn on or turn off the Turbo function. After the Turbo function turned on, the signal of
Turbo will display. The signal will be automatically cancelled if changing the mode or fan speed.
6. button
Press this button to set left & right swing angle cycling as below:
7. button
Press this button to set swing angle,which circularly changes as below:
This remote controller is universal. If it receives threes kinds of following status,the swing angle will remain origial.
If guide louver is stopped when it is swinging up and down,it will remain its present position.
8. CLOCK button
Press this button, the clock can be set up,signal
if continuously press this button for 2 seconds above,in every 0.5 seconds, the value on ten place of Minute will be increased 1.During
powered on, 12:00 is defaulted to display and signal
value is Clock value, otherwise is Timer value.
Technical Information
ATUO
Medium fan
AUTO COOL
OFF
OFF
blink and display.Within 5 seconds, the value can be adjusted by pressing + or - button,
will be displayed. If there is signal
Medium-high fan High fan
" is displayed and the indoor fan will continue
DRY FAN
(only for cooling and heating unit.
As for cooling only unit, it won't
have any action when it receives
the signal of heating operation.)
HEAT
be displayed that denotes the current time
.
After
25