Rangemaster 110 Dual Fuel User Manual page 32

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
20. To Remove RH Oven Inner Back.
Open RH oven door and remove 4 screws and washers
securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the 4 screws and washers are
fully tightened.
21. To Change Fan in RH Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to
the fan noting their position. Remove oven inner back
(see 20). Hold the fan blade and remove the centre nut
(left hand thread) 2 brass washers, fan blade and Circlip.
Unscrew fan retaining nuts and washers (3 off each)
and lift the fan away from the rear of the cooker. Fit new
fan and reassemble in reverse order. Check operation of
oven.
22. To Remove RH Oven Element.
Disconnect from electricity supply.
Remove oven inner back (see 20).
Remove 2 screws from the top of the element and
1 from the bottom of the element in side the oven.
Lift element out carefully, disconnect the terminals
connected to the element noting their positions. If it is
not possible to disconnect the leads in this way, pull
cooker forward to gain access to the rear, remove
screws securing the electric cover to the back sheet and
remove cover and disconnect the terminals from the
rear.
Fit new element, and reassemble in reverse order.
Check operation of oven.
23. To Remove LH Oven Elements.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Remove the 4 terminals connected to the
top element noting their position. Remove 2 screws and
washers securing the bottom element cover. Remove
the 2 terminals connected to the bottom element noting
their position. Remove 2 screws and washer from the
bottom element support. Remove 2 screws and washer
from the element bracket and withdraw the element. Fit
new element, reassemble in reverse order. Open LH
oven door and remove 2 screws and washers securing
the top element heat shield. Remove 2 screws and
washers from the top element bracket and withdraw.
Fit new element, reassemble in reverse order. Check
operation of oven.
24. To change oven light bulb.
LH Oven
Remove the oven furniture and side linings. Remove the
oven rear liner.
RH Oven
Remove the oven inner back (see 20). The oven light
cover is now accessible. Unscrew the cover.
Unscrew the bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS.
It must be a special bulb, heat resistant to 300°C.
32