Advertisement
2_RP2420 EN
6/21/01
11:58 AM
THE CD PLAYER
EN
Listening to a Compact Disc
1. Slide the OPEN switch to the right
to open the door. Insert a disc and
press lightly on the centre to lock. Close
the door. Press PLAY/PAUSE button. Rd
DISC will appear in the display. Then,
the total number of tracks
and time of the CD will
be displayed. If the
CD-R / RW COMPATIBLE
disc compartment
• 1 bit d/a convertor •
esp x
P
is empty or the
1
bass boost
1
2
disc cannot be
minute
played, No Disc
will appear in
the display.
45
2. You can also
change tracks or
quickly listen to
part of a track by
pressing down or
holding
or
.3. Slide CONTROL switch to
HOLD position to lock the button to
avoid accidental activation of unwanted
functions.
Listening to a CD in your car
(For RP2425 / RP2427 only)
1. Select a power source (either
battery power or the car DC adaptor)
2. Insert the cassette adaptor into the
5
Page 8
tape deck and plug the cord into the
CD player's HEADPHONES jack.
3 . Insert a compact disc and press PLAY/
PAUSE button. Adjust CD player's volume
to a mid level (make sure the Bass Boost is
turned off).
4. Use the car stereo to adjust vol-
ume, tone . Adjust the vol-
ume of your CD player
for better volume
control.
5. Before ejecting
the cassette after
you have finished
listening, make
sure the car
stereo's volume is
turned down.
The ELECTRONIC
SHOCK PROTECTION*
system prevents
sound interruptions
45
when impacts or
vibrations occur.
Electronic anti-
shock consumes less
power and increases the battery life.
Therefore, the ESPX function is always
ON.
After many successive impacts, the buffer
might be emptied causing a brief sound
interruption for the memory to reload.
The buffer is 45 seconds long.
THE CD PLAYER
Repeating/Intro scan
Note : To prevent excessive battery
consumption, the unit switches off
You can replay the entire CD or one
automatically in all modes after 30s if
track as many times as you wish as well
no key has been activated.
as listen to the beginning of each track for
10 seconds.
You can program up to 24 tracks.
Press MODE successively to
To play your program again, press play.
1. Replay the entire CD .
To add/edit tracks to the program, go to
2. Replay the current track.
stop mode ; press and hold P button
3. Play the beginning of each track
again. Refer to step 2 of the above
for 10 seconds.
paragraph.
(The number of the track being played will
be displayed and SCAN will appear.)
Press P to turn program mode on, then
4. Press again to the function de-
press PLAY/PAUSE and
select.
program.
To cancel your program, press and hold
Program
the mode key when you are in the stop
mode. ERASE will appear in the display.
This function lets you listen to the tracks
The program will be automatically
you
canceled.
selected in the order you want. The CD
To exit program mode, remove P from the
player must be in Stop mode.
display by pressing STOP then P.
1. Press P button. P will appear in the dis-
play.
2. Select the track to store by pressing
& press P again to confirm.
or
3. Return to step 2 to store other tracks.
4. Press PLAY/PAUSE button to listen to
your programming.
EN
to check the
6
Advertisement
