Connecting To Audio-Visual Components; Connecting Antennas - RCA RTD160 User Manual

RTD160-EN receiver 6/10/04 2:36 PM Page 8
Getting Started

Connecting to Audio-Visual Components

It is recommended that you should only use one kind of connection method listed
below.
VCR
1
SAT
Component video (component cable is not supplied with this unit)
Component video terminal provides the best quality for video signal. If there is no component socket available on
your TV set, check whether your TV has another Video socket (Composite, S-video) that you can use to connect
your player.
S-video
S-video provides a better connection for the video portion of the signal than composite video (yellow color terminal). When
connecting S-video cable, a Composite video cable (yellow RCA connector) must also be used.
Progressive scan
You can enable the progressive scan function through the main menu only if the following requirments are fulfilled:
1. Your TV supports progressive scan function.
2. Component video output is used.
4
TV
Pr Pb Y
COMPONENT VIDEO OUT
PROGRESSIVE SCAN
Connecting the Antennas
Pr Pb Y
COMPONENT VIDEO OUT
PROGRESSIVE SCAN
The FM antennas connect to the FM terminals on the sys-
tem's back panel.
They must be hooked up in order to have clear reception.
Getting Started
Tip:
EN
• For FM reception, extend antenna to its
full length and arrange the antenna at dif-
ferent parts of the room until the recep-
tion is optimized.
5