Table of Contents
Advertisement
TV + DVD + VCR
1. Connect your DVD Player to your TV.
A. Connect the audio (white and red) cables to the CMP1 L and R Audio jacks on the back of
the TV and to the Audio Output jacks on the DVD player.
B. Connect three video grade cables to the CMP1 Y PB PR jacks on the back of the TV and to
the Y PB PR jacks on the DVD player.
Notes:
If your DVD player does not have Y PB PR jacks, but does have an S-Video jack, connect the
player to the VID1 S-VIDEO jack on the TV using an S-Video cable.
If your DVD player does not have an S-Video jack, connect the player to the VID1 V (Video)
jack on the back of the TV using a video cable.
Important: If you use the VID1 S-VIDEO or V (Video) jack to connect your TV to the DVD
player, you must connect the audio cables to the VID1 L/MONO and R jacks on the TV.
2. Connect your VCR to your TV.
A. Connect a coaxial cable to the VCR's antenna output and to the ANTENNA/CABLE Input
jack on the TV.
B. Connect the audio (white and red) cables to the VID2 L/MONO and R Audio jacks on the
back of the TV and to the Audio Output jacks on the VCR.
C. Connect the video cable to the VID2 V (Video) jack on the back of the TV and to the Video
Output jack on the VCR.
3. Make sure cable or antenna is connected to your VCR.
Connect the coaxial cable from your cable outlet or antenna to the antenna input on the VCR.
Chapter 1
Connections & Setup
Go to page 14
11
Advertisement
Table of Contents
