RCA DRC8060N User Manual page 8

Chapter 1: Connections and Setup
AC IN
OUTPUT: These jacks send the content (audio and video) from your DVD recorder OUT to the TV so you can see it on the TV screen and hear it through the TV's
speakers.
VIDEO: Color coded yellow, the video cable you use with this jack provides better quality than an RF coaxial cable but isn't as good as S-Video.
AUDIO L (left): Color coded white, connect corresponding audio cable to TV's Audio Left Input jack.
AUDIO R (right): Color coded red, connect corresponding audio cable to TV's Audio Right Input jack.
DIGITAL AUDIO OPTICAL OUT - DVD PLAYBACK ONLY: If you have a Dolby Digital or DTS receiver or decoder
with a Digital Audio Optical Input jack, you can achieve enhanced sound quality during DVD playback by connecting a
digital optical cable (not supplied).
CH3/Ch4 Switch This switch is also found on VCRs—it corresponds to the TV channel you would use to watch a disc if you only have your TV connected to the DVD
recorder with an RF coaxial cable via the CABLE/ANTENNA OUTPUT jack (if the switch is set to CH3, you would tune the TV to channel 3). However, the connections
illustrated in the User's Guide show a preferred connection using audio/video cables or an S-Video cable.
CABLE/ANTENNA INPUT: Connect an RF coaxial cable from an off-air antenna, cable box, or cable outlet to this jack. The cable is sending the programming from the
source to the DVD recorder.
CABLE/ANTENNA OUTPUT: Connect an RF coaxial cable (provided) to this jack and to the Cable/Antenna Input jack on your TV. It is important to connect this cable
so that your TV receives programming even when the DVD recorder is turned off.
6
HDMI OUT
PROG.
SCAN
OFF ON
Graphics contained within this publication are for representation only.
S-VIDEO
INPUT COMPONENT VIDEO OUT OUTPUT
VIDEO
Y
IN
L
Pb
AUDIO
AUDIO
OUT
R
Pr
DIGITAL
AUDIO OUT
VIDEO
CABLE/ANTENNA
L
R
OPTICAL
CH3 CH4
INPUT
OUTPUT