ENGLISH
2
Introduction
.
The unique Thermoflow System
This new Philips beauty hairdryer has been specially designed to meet your
personal needs. The Thermoprotect hairdryer features the innovative
Thermoflow System that uses more air but less heat. This system dries your
hair just as quickly as an ordinary hairdryer without the risk of dehydration. It
preserves your hair's natural moisture level and leaves your hair with the
lustre, body and richness you love. To get beautiful hair you need to dry it,
not dehydrate it.
General description
.
A
Air inlet grille
B
Air outlet grille
C
Side buffer
D
Quick-Dry setting
E
Cool Shot
F
Airflow & on/off switch
G
Hanging loop
H
Comb diffuser
I
Concentrator
J
Care Mode light
Important
.
Read these instructions for use carefully before using the appliance and save
them for future reference.
Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
If the mains cord is damaged, it must be replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to
avoid a hazard.
Keep this appliance away from water! Do not use this product near or
over water contained in baths, washbasins, sinks etc. When used in a
bathroom, unplug the appliance after use since the proximity of water
presents a risk, even when the hairdryer is switched off.
For additional protection we advise you to install a residual current
device (RCD) with a rated residual operating current not exceeding
30mA in the electrical circuit supplying the bathroom. Ask your
installer for advice.
Keep the appliance out of the reach of children.
Never block the air grilles.
If the appliance overheats, it will switch off automatically. Unplug the
appliance and let it cool down for a few minutes. Before you switch
the appliance on again, check the grilles to make sure they are not
blocked by fluff, hair, etc.
Thermoprotect super silent 1500 HP4858/00
Always switch the appliance off before putting it down, even if it is only
for a moment.
Always unplug the appliance after use.
Do not wind the mains cord round the appliance.
Using the appliance
1
Put the plug in the wall socket.
2
Switch the appliance on by selecting the desired setting: (fig. 1).
÷:Quick-Dry setting - to dry shower-wet hair very quickly and safely
(fig. 2).
We advise you to use the Quick-Dry setting only briefly to avoid dehydrating
your hair.
The Care Mode light goes out when you select the Quick-Dry setting.
II: Care & Dry setting - strong airflow and caring temperature for fast
but gentle drying.
I: Styling setting - low airflow, especially intended for styling.
The Care Mode light goes on when you select the Care & Dry setting or the
Styling setting to indicate that you are drying your hair gently.
O: Off.
3
Dry your hair by making brushing movements while holding the dryer
at a small distance from your hair.
4
The Cool Shot fixes the style you have created with cool air (fig. 3).
Press the button for a short time.
Attachment
Concentrator
The concentrator enables you to direct the airflow at the brush or comb
with which you are styling your hair.
1
Connect the concentrator by simply snapping it onto the appliance.
Disconnect it by pulling it off (fig. 4).
Cleaning
Always unplug the appliance before cleaning it.
Never rinse the appliance with water.
1
The appliance can be cleaned with a dry cloth.
2
The attachment can be cleaned with a moist cloth or rinsed under a
running tap.
Remove the attachment from the appliance before cleaning it.
Make sure the attachment is dry before using or storing it.
Storage
Always unplug the appliance before storing it.
Put the appliance in a safe place and let it cool down.
Do not wind the mains cord round the appliance.
The appliance can be stored by hanging it from its hanging loop.
.
.
.
.
4222 002 28195
2/15