KitchenAid 730-0953 (NG) Installation Instructions And Use & Care Manual page 43

Freestanding outdoor grill
Hide thumbs Also See for 730-0953 (NG):
Table of Contents

Advertisement

Available languages

Available languages

3.
Remove the burner from the grill by lifting the burner out.
4.
Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP brass orifice from the end of the gas valve.
The main burner NG orifice is located behind the LP orifice,
so no additional orifice needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the LP orifice is properly removed
inside of the burner opening.
5.
Reinsert the burner and reattach using the cotter clip and
screws previously removed. Repeat the procedure for
each main burner.
6.
Position the igniters so they are 1/8" (3.2 mm) away from
each burner.
Change the Sear Burner Orifice
1.
Use a screwdriver to remove screw from the igniter pin.
2.
Remove two screws on the rear of the searing burner. Lift
the burner starting from the back, as shown.
A
3.
Use a 6 mm socket wrench or 6 mm nut driver to remove
the orifice.
4.
Replace with the Natural gas orifice.
43

Advertisement

Table of Contents
loading

Table of Contents