Table of Contents
Advertisement
5.
In PIN, enter a PIN of between 1 and 16 characters, and
select Done.
6.
Enter the same PIN on the other device.
7.
If desired, enter the name of the other device in Name,
and select Done.
To accept a bond:
1.
Make sure that Bluetooth is turned on and in Discoverable
mode.
2.
When prompted to bond with the other device, select
Yes.
3.
In PIN, enter a PIN of between 1 and 16 characters, and
select Done. You must enter the same PIN that was
entered on the device requesting the bond.
4.
Optionally, you can enter the name of the device requesting
the bond in the Name field.
5.
Select Done. The bond is now created. You can now
exchange information with the other device.
To delete a bond:
1.
Select Settings > Bluetooth > Bluetooth from the Start
menu.
2.
Select Bonded Devices from the menu.
3.
Select the bond you want to delete, then select Delete
from the menu.
NOTE: Select Settings > Bluetooth > BT Setting to enter a
name for your device; to enable/disable Beam Authentication
requirements; or perform ActiveSync setup (bond with other
Bluetooth device which supports serial port or ActiveSync
profile as your ActiveSync partner).
Smartphone User Manual
95
Advertisement
Table of Contents
