General Assembly Instructions - Vacmaster VBVB611PF 1101 Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screw driver is required.
1
6 6
11
WARNING
THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on carton content list on page 6 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
page 13 for installation instructions (Fig. 6 & 7).
8. Place the power head back on the collection tank and secure into place using the latches. Make
sure the power head is properly installed with the blower port positioned in the back of the unit
(Fig. 9 & 10).
9. Insert the locking end of the hose into the vacuum port of the collection tank and lock into place
(Fig. 11).
10. Choose the desired accessory and insert onto the end of the hose or extension wand (Fig. 12).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
Do not change the plug in any way. Double insulation
grounded power cord and grounded power supply system.
3
2
7
8
12
: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
4
9
eliminates the need for the three wire
8
5
10