Table of Contents
Advertisement
WOBBLE:
NOTE: CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE
MOUNTED ON A RUBBER GROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING IT WILL
CAUSE EXCESSIVE VIBRATION. MOVEMENT OF A FEW CENTIMETRES IS QUITE ACCEPTABLE AND
DOES NOT SUGGEST ANY PROBLEM.
TO REDUCE THE FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH FIX THE MOUNTING
BRACKET AND DOWN ROD ARE SECURE.
NOTE: This fan has been precision balanced at the factory and may need re-balancing. Balancing kit
supplied can used if required.
How to Use the Balance Kit
1. Tighten all screws.
2. Unscrew the blades and fix them back at different
combination of positing on the motor.
3. Measure the level between the ceiling and all blades.
4. Use the blade Balancing kit provided if the fan still
wobbles.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour <breaking-in= period, most noises associated with a new
fan disappear during this time. Please note that this is not a product fault and as such is not covered under
warranty – All electric motors are audible to some extent.
CARE AND CLEANING:
Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth
to avoid scratching the paint finish. Please turn power off when you do so.
Do not use water when cleaning your ceiling fan. It could damage the motor or blades and create the
possibility of an electrical shock.
The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn off the power at the main switch before attempting to clean your fan.
Ceiling Fan model
SEA1403LO-DC
SEA1403WN-DC
AFTER INSTALLATION
TECHNICAL INFORMATION
Rated Power
Rated Voltage
(motor)
240 - 265 VAC
240 - 265 VAC
9
Rated Power
38W
n/a
38W
n/a
(lamp)
Advertisement
Table of Contents
