Resetting The Microprocessor; Use And Care Of The Remote Control - Pioneer XDV-P6 Operation Manual
6-disc multi dvd/vcd/cd/mp3/wma player
Hide thumbs
Also See for XDV-P6:
- Installation manual (9 pages) ,
- Installation manual (5 pages) ,
- Service manual (92 pages)
Table of Contents
Advertisement
Before You Start
When using this product with a
Pioneer component featuring
an IP BUS input
% Select the IP BUS mode.
For more details, refer to the installation man-
ual.
When using this product with a
Pioneer component that does
not feature an IP-BUS input, or
another company’s product
% Select the STAND ALONE mode.
For more details, refer to the installation man-
ual.
Resetting the microprocessor
Pressing RESET lets you reset the micropro-
cessor to its initial settings.
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! When changing the mode switch setting
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1
Turn the ignition switch OFF.
Section
02
2
Press RESET with a pen tip or other
pointed instrument.
RESET button
Use and care of the remote
control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus (–) poles pointing in the proper di-
rection.
! When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
CAUTION
! Use only one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is not
used for a month or longer.
! Do not recharge, disassemble, heat or dispose
of the battery in fire.
Page 9
En
- Quick Links:
- About this Unit
Hide quick links:
Advertisement
Table of Contents
