Mounting DAHL system:
>
Position the locking plate 503125 on the bottom of the wheelchair.
The holes for positioning are already provided in the battery box.
>
Fasten the locking plate inside the battery box with the adaptation
set 502064 and screw the five countersunk screws from below with
the DAHL nuts 500759. Adjust the height of the locking rail (1.2).
>
Additional intermediate pieces (1mm, 2mm, 3mm, 8mm, 10mm)
may be required. The fine adjustment is done when adjusting the
wheelchair at the DAHL docking station in the vehicle. Finally, glue
the six spacers 502071 to the bottom of the battery box so that the
batteries lie flat when inserted and cannot slip.
>
Once you have adjusted the height of the locking rail, screw
in the pan-head screws medium tight w ith a screw lock.
If using the power height adjustable Dahl VarioDock, additional spa-
cers will not be needed for adjusting the height.
86
Fig. 43: Position of the Dahl system
Fig. 44: Fastening of the Dahl system
Loading and transporting the power wheelchair