Operation Of Lamp Head; Quick Start Via Sterilizable Handle - MIMSAL MIMLED 600 Manual

3.2.1 OPERATION OF THE LAMP HEAD
The controls for switching on and off (position 3) and for brightness control (position 6) are
integrated into the top of the lamp head. The handle allows you to adjust the luminosity by
turning the handle.
360º
Figure. Schematic representation of the MIMLED 600 | MIMLED 1000 lamp head.
270° joint.
360° joint/interface. Support system allows rotation around the horizontal axis.
ON/OFF switch.
Heat sink.
Adjust brightness in 6 (MIMLED 600) or 10 (MIMLED 1000) steps: (+) increase the
illuminance level and ( - ) decrease the illuminance level.
Lateral handle strip (for non-sterile operation and positioning of the lamp head).
Illuminance display (visualizes the current setting of the illumination in 5 steps).
Sterilizable handle with quick start and bright-ness control.

3.2.2 QUICK START VIA STERILIZABLE HANDLE

For time-critical applications (e.g: trauma room), the light can be turned on with a slight twist
of the sterilizable handle. The direction of rotation is independent of this. The light starts at
the lowest brightness (10.000 lux) and can thus also be easily started and operated in a sterile
manner. After the procedure, the light must be switched off using the non-sterile ON/OFF
button on the top of the housing.
Figure. Schematic representation of the lamp head
10
270º